use an epoxy glue like west system or something similar, it was designed for exactly this type of work and is easy to use and can be used to clear coat the gun afterwards,as for cost you can buy it in small and large bottles and I think it would be more cost affective than gorilla glue, it is better to first coat the timber in unthickened glue first and wait afew minutes for it to penetrate and then apply thickened glue and clamp ,it is a very forgiving glue and as long as you mix it properly it is hard to make a bad joint, you should be able to to buy thickening agents at the same place you but the glue and it is extremely cheap , ANDREW.
|
