...and you chose a pneumatic to get away from those rubbery band guns??
Check out this zero cost mod. it will keep your gun from getting bashed on the rocks. I mainly did this because some entry/exit dings on my guns cylinder were so big i thought they would disturb the pistons travel. The mod. does NOT affect the buoyancy as far as I can tell.
- go to a tire change workshop, and beg an old car o tractor inertube
- cut withs sharp scissors into a spiral, making a strip 1/2" to 3/4" inch wide, DON'T be too fussy, just cut on sight
- start at muzzle, rotating, stretching and pushing wound part upwards (towards muzzle) to lessen gaps
- at trigger guard tie off as shown in detail
I have since put on extra spare loop near the muzzle, that I use to retain the braided spear line excess tight, it works a treat.
Cheers
|
