I splashed out and baught a C4 130 today, it vost me what you guys on the other side of the Atlantic pay for adecent gun so...
Anyways, the shop wasn't all that well stocked on pre made rubber, and since it takes the screw in ends, I am not sure if I can make those up myself as opposed to the ball type.
This guns takes two rubbers, it is a very impressive pieve of work, and very, very simple in overall desogn.
I am shootin 1.7 7mm spears for th emost part, I also have a 1.6 and a 1.5 which I will try for accuracy over time.
I was going to rig it with 2 OMER 18mm 32cm bands, which dyneema wishbones but the ones in the shop(only one pair) did fit properly for some reason. Just to check it was all OK we tried some other rubbers that all fit, so it must have been a defectinve set of Omers.
Can anyone advise on setup for this gun, which comes "naked" from the shop. I want to use it for bluewater and some open clear water reef fishing most likely on trips away since locally there isn't much call for such a gun. Apart from trying it on those deeper jaunts where the biggger fish stay "just out of range" of a normal 110.
If forcing the screw in ends is a possibility I would be more than hapy to make sme bands up from scratch, even more so if someone can reccomend a particular brand of aftermarket brand of rubber.
Thanks.
Anyways, the shop wasn't all that well stocked on pre made rubber, and since it takes the screw in ends, I am not sure if I can make those up myself as opposed to the ball type.
This guns takes two rubbers, it is a very impressive pieve of work, and very, very simple in overall desogn.
I am shootin 1.7 7mm spears for th emost part, I also have a 1.6 and a 1.5 which I will try for accuracy over time.
I was going to rig it with 2 OMER 18mm 32cm bands, which dyneema wishbones but the ones in the shop(only one pair) did fit properly for some reason. Just to check it was all OK we tried some other rubbers that all fit, so it must have been a defectinve set of Omers.
Can anyone advise on setup for this gun, which comes "naked" from the shop. I want to use it for bluewater and some open clear water reef fishing most likely on trips away since locally there isn't much call for such a gun. Apart from trying it on those deeper jaunts where the biggger fish stay "just out of range" of a normal 110.
If forcing the screw in ends is a possibility I would be more than hapy to make sme bands up from scratch, even more so if someone can reccomend a particular brand of aftermarket brand of rubber.
Thanks.