• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

Cetma s-swing foot pockets fit carbon blade

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.
0

007001

Member
Oct 2, 2018
1
0
11
39
Hi all experience freediver,
I am really deep like the Cetma s-swing foot pockets because it fit the foot. when you kicking, a little bit force when DYN.
However, I have some question would like to ask.
What types of carbon blade is perfect fir the to install s-swing?
Is it molchanovs c1 blade fit to assemble?
What kind of method is good to assemble?

Thanks to advice me
 
I've seen the S-WiNG used with Alchemy, CETMA (obviously), DiveR, etc... pretty much any blade will fit the S-WiNG, but it is definitely optimized for CETMA blades with the longer section after the angle, as well as the longer water rails. The pocket its self has a ton of reinforcement at the base and bottom of the heel area, that's why they work so well with blades that have the shorter section after the angle.

I've seen folks add longer water rails to their blades so that they're able to utilize the flow design of the S-WiNG, but that's not necessary.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…