• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

Gabbiano 20mm band replacement...

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.

the_unplugged

New Member
Jul 28, 2009
4
0
0
Hi there,

I have a 2009 Seatec Gabbiano 90, and need to replace the bands, which are 20mm. I'd prefer to switch to 16/18mm rubbers as I don't feel I need the power of the 20's for the extra effort required loading them!

I understand from reading older posts that I probably need to replace the head and wishbone, as these may have a 20mm specific thread, unlike most other manufacturers.

Before going ahead and ordering these bits, I just wanted to confirm I need them. The threads themselves on the bands I have measure 16mm in diameter; is this larger than the threads of normal 16mm rubbers?

Any help much appreciated.
Matt
 
Lol, quite! :t I should have said (to avoid mocking!), I'm not replacing the bands because of the difficulty loading per se; they are getting pretty worn too!
 
lol, sorry, was drunk when i posted and didnt read the whole post... :crutch

im not familiar with the gabbiano, but i think its screw in rubbers only right? you can buy some adapters that allow you to tie your own bands. this means you can also put spectra/dyneema wishbones in to save your fingers.

you say your guns a 90, so i think 16mm is sufficient. just make sure you dont cut them too short.

btw, the threads your refering to are universal i think
 
If the screws are 16mm, get a Seatec Stinger, or any Omer bands or H. Dessault: they'll al fit in.

If the screws are 20mm, either you find new bands with 20mm screws (rare to find these days) or you get a 16mm fitting for your muzzle.

BTW, I'm looking to buy for myself a used Gabbiano 90 with old handle.........................
 
No worries johnnyp, you can't htfu too much! I'll keep those adapters in mind as dyneema wishbones sound like a good idea.

Thanks for the reply Spaghetti, I double checked and the screws/threads are definitely 16mm, so I don't need a new fitting; very handy as getting hold of one looked a bit fiddly.

I'm afraid i'm very happy with my Gabby at the mo, it's a great gun. I'll let you know if I change it any time soon!
 
DeeperBlue.com - The Worlds Largest Community Dedicated To Freediving, Scuba Diving and Spearfishing

ABOUT US

ISSN 1469-865X | Copyright © 1996 - 2024 deeperblue.net limited.

DeeperBlue.com is the World's Largest Community dedicated to Freediving, Scuba Diving, Ocean Advocacy and Diving Travel.

We've been dedicated to bringing you the freshest news, features and discussions from around the underwater world since 1996.

ADVERT