This uses the helmet mount base as supplied with HD Helmet hero.
1. take apart noting how buckles are threaded. Remove sponge padding, keep adhesive clean to allow re-sticking
2. Heat and bend where shown, use a small flame etc. Bend to suit your wrist diameter.
3. Re-thread long strap as shown, stitch inner end in place to also fix one buckle
4. Once threaded and tested glue loose end after folding over to prevent it pulling back through the buckles
5. Replace sponge.
To wear: place over wrist and tighten clamp 1 first and then clamp 2. Double security!
1. take apart noting how buckles are threaded. Remove sponge padding, keep adhesive clean to allow re-sticking
2. Heat and bend where shown, use a small flame etc. Bend to suit your wrist diameter.
3. Re-thread long strap as shown, stitch inner end in place to also fix one buckle
4. Once threaded and tested glue loose end after folding over to prevent it pulling back through the buckles
5. Replace sponge.
To wear: place over wrist and tighten clamp 1 first and then clamp 2. Double security!
