here are the pics my new gun. i built two, but one is on display at the local spearfishing shop. i will take pics of that one later today or tomorrow. this is the longer of the two. it is 62" overall. 1.6 inches wide 1.4 inches tall. 6 piece teak laminate. the barrel was trued, then a .5 inch slot is routed down the center. i fill this groove with west system mixed with graphite, and 40% milled fiber. then i cut the track into that. neptonics trigger mechanisms and handleframes, and line anchors. handle on this one is hand shaped,(by me) brazilian walnut,("ipe") these two both shoot 9/32 spears,(riffe) the smaller one on the shop is 50 " overall
-
Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:
- Join over 44,280+ fellow diving enthusiasts from around the world on this forum
- Participate in and browse from over 516,210+ posts.
- Communicate privately with other divers from around the world.
- Post your own photos or view from 7,441+ user submitted images.
- All this and much more...
You can gain access to all this absolutely free when you register for an account, so sign up today!
guns # 2 and # 3 complete
- Thread starterjtkwest
- Start date
Thread Status: Hello
, There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.
It can take a long time to get an up-to-date response or contact with relevant users.
