I lost the spear for my gun, i can't seem to find one online, does anyone know anybody who stocks them? or can i use a spear from a different brand? cheers
Alfiet, you certainly buy generic shaft, which is not made for any specific model. Like mentioned earlier, you will need to make sure the shaft you are buying fit your gun. Your shaft has to be
1. 7mm diameter, preferably. You can use thinner shafts, but original for your gun was 7mm.
2. Rear end must be half moon, like mr.X mentioned, american shafts with square lock will not work with your trigger.
3. Rear end must have a flared portion, which is wider (lool like hammered flat), so that sliding ring will have something to catch onto. This is generally, any european shaft made for closed muzzle spearguns. Shafts without that flaring will need some engineering, perhaps drilling and pinning.
4. It absolutely has to be notched shaft. Shark fins might not fit through closed muzzle.
5. the length, as mentioned earlier, will be somewhere at 98cm, this is the smallest that will work, if the shaft is threaded, with no tip. If shaft you are thinking about buying has a flopper already, then go with 105 cm as abolutely smallest. It is better if you measure yourself and not rely on what I said.
With so many specific requirements, get ready to spend hours searching on internet for the shaft for this gun. Out of 100’s of shafts, there maybe one that will work, and not every online store will have those. But, those shafts with notches and flares, and threaded ends are often cost less than 20$, maybe even 10$, so it might be worthwhile. Made from black steel, sometimes anodized, but could be bare and as such will rust and bend easily.