Mares cyrano 850 set up

[canada]

Please help. What attaches to what? I have the spear w the heavy mono
Material to it but am
Confused about the black cord material and where it goes and the rubber ring

Also where does the extra line go when the spear
Is
In? Do I just put
Pressure on the spear
To get it
Down the shaft. Thanks.
My first gun. Too rough to use it today so setting it up
Posted via Mobile Device

 

[settingsteel]

Your best bet is to take it to the dive shop you purchased from and have them help you out. That said I'll give it a shot.
The cord/rubber ring if I recall is to set up your shooting line/bungie (that would be your rubber ring). I usually use this ring as a loop to hold the loose end of my wt belt, as it is not that good a bungie. It seems you bought the mono, so head back over to your LDS and get a decent bungie cord (which serves the purpose of holding your shooting line tight to the barrel) attach the new bungie to the anchor which is just below the muzzle (looks like a "J"). Next use either the mono or shooting line (the one that came with the gun) and attach to the line retention ring (the little black thing around the shaft), put your shaft inside the muzzle BUT DO NOT LOAD, now follow the line from the tip of the muzzle (the line retention ring with line attached should be resting there) down the barrel to the release wrap it around and back up to the plastic anchor (which is where you attached the bungie) stretch your bungie a tad and tie the shooting line to it. With an 85cm one wrap should suffice.