• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

Need ideas

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.
S

SpearTuna

Active Member
Feb 17, 2011
11
0
36
A stock that I laminated together has a bow in it. (warped) Any ideas on how I can straighten it out? I did the laminates to act against each other, doing the grains in opposite direction, but it's still warping on me.
 
You may have laminated wrong. The first time I did it I turned end for end and top for bottom, one cancelled the other. Either/or is the answer. If my memory hasn't failed completely. I was convinced that the only thing to do after lamination is mill it square or leave one side alone and mill it into a U-shape.
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…