• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

Need Your Comments about Speargun Combination

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.

Demir

Active Member
Feb 4, 2005
21
0
36
48
Hi Friends,
I bought a new 110 cm wooden speargun. I want to use double rubber on this gun but I need your suggestions for the combination.

Double 16 mm ruber with 6,3 or 6,5 mm spear?
OR
Double 18 mm rubber with 7 mm?

I want to use this gun for Dentex hunting. Waiting your responses
 
Hi Demir,
A 110 is good for Dentex, a 6,5 or 7 are the best shaft sizes in my opinion, which one to go with should be determined by the size of fish taht you are likely to find. Regarding the rubbers, you should remember that Dentex have the tendancy to stay a bit wide and have tough scales especially if you hit them at an angle, which is usually the case, plus, remember that rubbers lose power as you go deeper, so the depth that you will be fishing at will also have an effect on your guns performance if you fish deep +25 meters.

Ciao!
 
You must log in or register to reply here.
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…