Riffe Line Release Mechanism ???

[mcoaker2]

Hey everyone,

I'm almost finished with my first DIY gun and have had good luck ecxept with the line release mechanism. I'm using a Riffe trig mech, line release and and shaft, and i can't figure out how to install the line release. Can someone PLEASE HELP? Maybe a few quick tips or point me toward a good thread. ANy help is greatly appreciated.

Thx,
Matt

 

[Søren]

Quick tip:
Put the trigger mech on the side of the gun and measure the dimensions and then cut a hole for the line release in the side of the gun stock you have chosen.
Perhaps use an angle like the photo (I'm not sure what it's called)
Please elaborate the question.

 

[mcoaker2]

I finally got it to work. Thanks though!