• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

selling two neptonics ball bits

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.

jtkwest

recreational user
Dec 2, 2007
808
144
0
i am putting this here because i want these to go to one of the db gun builders, and i know I never look at the for sale section. i hope the db staff wont mind. i 'm not looking to make alot off of them, i just got custom ones made , so i am selling two neptonics ball cutter bits. - one is for 7mm shafts (aka 9/32") one is for 8mm (aka 5/16"), both have a 1/4" shank to fit into 1/4"collet on your router. . i will sell both for 50$ plus shipping. i dont imagine it would cost much to mail them. unless you want overnight or airmail to uk or something. in which case , its on you to pay it. i used each of them 10 times approximately. but they are still sharp. no nicks at all in them. i am anal about keeping my tools ,(particularly router bits) in good condition. they have NEVER been jostled or banged into by any steel tools in the workshop AT ALL! i am very careful. i am sure they will cut many dozens more tracks for anyone interested.
 

Attachments

  • bits 002.jpg
    bits 002.jpg
    104 KB · Views: 199
Last edited:
why are you selling them?
im interested in them :)

neptonicsystems is the only company that STOCKS ball bits for cutting tracks if you want a different variation you have to pay to have them cut custom from carbide. and they cost closer to a hundred each.
I ORDERED 3 CUSTOM BALL BITS WITH 3/16" shank, for 7mm ,7.5mm, 8mm ,(all slightly oversized of course) i am trying to sell off the old bits to help pay for the new custom bits ,(THEY are alot more expensive than these) if you want them, i wouldnt wait long. i dont imagine they will last long for sale. i know i wish i could have bought two slightly used bits for price of 1. BOTH sizes!. good deal for someone. i stand behind these bits. you WIL be very happy with the quality and condition, should you choose to buy. if i put them on spearboard, they will be gone in a day . but i wanted to see db builders get first whack at them. rsvp - i am going to bed soon. i will check email in the morning and again after work, so send me a pm if you (or anyone) is seriously interested.
 
Last edited: