Hello everyone,
I have a 1983 Beuchat Marlin speargun ( I think it is from 1983 or later). I have replaced the shaft with one of those cold rolled steel shafts and the shaft is always getting bent. i would like to replace it with a spring steel shaft, but I am weary of spending the money before I know it will fit. I am from Rochester NY, and there isn't a local dive shop where I can try these shafts out.
Below is a sketch of the replacement (new) and the original (old) speargun trigger mechanism cutout of the spear shaft. Both cutouts seem to work extremly well in my gun.
Currently I have the gun setup with an open muzzel (Biller metal muzzel) so I can replace the bands cheaply. Also I tend to run either one 3/4" band or two 16 mm bands with cable wishbones. My spears are around 6.5mm or 7mm and 4 feet long... i don't care if I go a few inchs shorter or longer (rather shorter).
Does anyone know what types of shafts I could possibly use in my gun?
new speargun shaft tail cutout:
half circle cutout
|___ |
|___ |
|___ |
|___ |
|___ |
|__ /
|_ /
| |
|_ \
|__ \
|___ |
|____|
Old Speargun Shaft Tail Cutout:
angle than squared off tail cutout
|___ |
|___ |
|___ |
|__ /
|_ /
|_ |
|_ |
|_ |__
|____|
I have a 1983 Beuchat Marlin speargun ( I think it is from 1983 or later). I have replaced the shaft with one of those cold rolled steel shafts and the shaft is always getting bent. i would like to replace it with a spring steel shaft, but I am weary of spending the money before I know it will fit. I am from Rochester NY, and there isn't a local dive shop where I can try these shafts out.
Below is a sketch of the replacement (new) and the original (old) speargun trigger mechanism cutout of the spear shaft. Both cutouts seem to work extremly well in my gun.
Currently I have the gun setup with an open muzzel (Biller metal muzzel) so I can replace the bands cheaply. Also I tend to run either one 3/4" band or two 16 mm bands with cable wishbones. My spears are around 6.5mm or 7mm and 4 feet long... i don't care if I go a few inchs shorter or longer (rather shorter).
Does anyone know what types of shafts I could possibly use in my gun?
new speargun shaft tail cutout:
half circle cutout
|___ |
|___ |
|___ |
|___ |
|___ |
|__ /
|_ /
| |
|_ \
|__ \
|___ |
|____|
Old Speargun Shaft Tail Cutout:
angle than squared off tail cutout
|___ |
|___ |
|___ |
|__ /
|_ /
|_ |
|_ |
|_ |__
|____|