• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

Trigger wont engage on Asso115

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.

Mufazalov

Well-Known Member
Dec 25, 2010
145
39
68
Hi, pneumatic gurus.
I was messing with a trigger on my Asso on dry land and it suddenly felt like it 'fell in'. After that the piston simply goes up and down (when I push it with the shaft @5bar) but doesnt get locked.
I took the trigger out and saw that the pin is just immovable for some reason.

Any suggestions?

I tried pressurizing the gun to 10-12 bar but to no avail :(
 
The coil spring that biases the sear lever may have tipped over and no longer pushes the rear of the sear lever down and hence the sear tooth up. If that happens then the sear tooth cannot catch the piston tail as the tooth stays depressed.
Asso mechanism.jpg
 
Last edited:
DeeperBlue.com - The Worlds Largest Community Dedicated To Freediving, Scuba Diving and Spearfishing

ABOUT US

ISSN 1469-865X | Copyright © 1996 - 2024 deeperblue.net limited.

DeeperBlue.com is the World's Largest Community dedicated to Freediving, Scuba Diving, Ocean Advocacy and Diving Travel.

We've been dedicated to bringing you the freshest news, features and discussions from around the underwater world since 1996.

ADVERT