I ordered a couple of shaftsfor my evo 70, and they are about 5" 12.4 cm longer than I need them to be. I have not loctited the cyrano shaft addapter on yet, what is the best way to shorten them? I could cut the rear off, but I believe that I would need to turn a section of the shaft on a lathe so that the 9/32 shaft could be threaded to 6mm. Or, I could cut the front off, but then would have to profile a new tip, drill and rivet the flopper back on. Also, if I cut the tip off, I would believe the new tip would not be as hard as the original, because the hardness is in the surface of the steel.