• Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:

    • Join over 44,280+ fellow diving enthusiasts from around the world on this forum
    • Participate in and browse from over 516,210+ posts.
    • Communicate privately with other divers from around the world.
    • Post your own photos or view from 7,441+ user submitted images.
    • All this and much more...

    You can gain access to all this absolutely free when you register for an account, so sign up today!

AB Biller 35 needs help...

Thread Status: Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.

shark_whisperer

New Member
Mar 14, 2007
16
4
0
Ive got a few questions if anyone would be willing to help out. I picked up a used AB Biller 35 recently and after trying it out today, only got about a 2-3 foot shot range before the shaft drops like a rock. The bands that it came with are 15mm( i think?) ambers (they look fairly worn, but not rotted or anything), but they dont feel like they give the shot any power, or feel like they take any effort to load either. Here's what I DO know.

1) Guns this short arent really long range guns.
2) Minimum band length depends upon some formula having to do with the wall thickness and total diameter?

Could I ostensibly put some newer, thicker or shorter rubbers on and achieve at least some degree of range increase?

thanks, i appreciate any feedback.
 
Am I correct to assume the guns 35in, being about 850mm. You should be getting about a 2m shot accurate range on this gun. I think a rubber replacement is in order, replace the existing ones with new 16mm bands and you should be sorted :)
 
thanks again for the reply!
I realize i somehow omitted the fact that the shaft is 8mm diameter. Would new bands still help, or does this change things a bit?
 
Yea it will but a 8mm shaft is very heavy for such a small gun, perhaps its made for the ling cod I hear about so often on these forums. If you keep the 8mm shaft Id perhaps try single 18mm instead of a 16mm band :)
 
Go for twin 16, meaning use to rubbers of 16mm at the same time, i belive your gun can take it without a problem.
 
Biller equips the "36" with two, 9/16 bands with 14 1/2 inch length. If you need more range than available with Biller rubber, drop a line to "internet spearguns" (Bill Kitto). They will ship you bulk rubber for $2/foot. Cut the lengths that you need and transfer the wishbones. Tie off the wishbones ("bridles") with thin nylon cord using a strangle knot. Range of the gun will be 6-8 feet measured from the outstretched fist.
 
i had the same problem when i got a biller 32. i replaced the bands with slightly longer 16' x 5/8"(16mm) bands and put a single flopper tip on it. the big rotating double flopper tip that was on it was slowing it down a lot and affecting penetration. it works great right now, i have great range with it, can kill easily at 9-12 feet.
 
DeeperBlue.com - The Worlds Largest Community Dedicated To Freediving, Scuba Diving and Spearfishing

ABOUT US

ISSN 1469-865X | Copyright © 1996 - 2024 deeperblue.net limited.

DeeperBlue.com is the World's Largest Community dedicated to Freediving, Scuba Diving, Ocean Advocacy and Diving Travel.

We've been dedicated to bringing you the freshest news, features and discussions from around the underwater world since 1996.

ADVERT