-
Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:
- Join over 44,280+ fellow diving enthusiasts from around the world on this forum
- Participate in and browse from over 516,210+ posts.
- Communicate privately with other divers from around the world.
- Post your own photos or view from 7,441+ user submitted images.
- All this and much more...
You can gain access to all this absolutely free when you register for an account, so sign up today!
Calculating Band Length
- Thread starterdaveduvet
- Start date
Thread Status: Hello
, There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.
It can take a long time to get an up-to-date response or contact with relevant users.
Dave there was a recent thread with that question. All the answers were there - I think 
http://forums.deeperblue.com/euro-s...and-problems-help-please-help.html#post784845 .
Dave
http://forums.deeperblue.com/euro-s...and-problems-help-please-help.html#post784845 .Dave
1. Measure the distance from the middle of the
band slot to the center cocking tab.
2. Double the distance ( for both sides of the gun )
3. Subtract the length of the wish bone. (Alexander and Riffe's are
approx 6", Daryl Wong uses about 3".)
4. Divide the number by 3 1/2.
5. This is the length of your powerband if you are using a standard 3 1/2
: 1 stretch ratio. This is a measurement of the powerband from knot to
knot. For actual rubber length, add 1" to this length or 1 1/2" in you
are tapering the ends of the powerbands.
If you have separate holes for each band as with the newer Aimrite/Wong muzzles, then rather than measuring from the center of the band slot (you don't have a slot) to the middle tab, measure from each hole to the appropriate tab, and you will have a different band length for each hole.
band slot to the center cocking tab.
2. Double the distance ( for both sides of the gun )
3. Subtract the length of the wish bone. (Alexander and Riffe's are
approx 6", Daryl Wong uses about 3".)
4. Divide the number by 3 1/2.
5. This is the length of your powerband if you are using a standard 3 1/2
: 1 stretch ratio. This is a measurement of the powerband from knot to
knot. For actual rubber length, add 1" to this length or 1 1/2" in you
are tapering the ends of the powerbands.
If you have separate holes for each band as with the newer Aimrite/Wong muzzles, then rather than measuring from the center of the band slot (you don't have a slot) to the middle tab, measure from each hole to the appropriate tab, and you will have a different band length for each hole.