So I'm starting my first speargun build. I'm building my own trigger too. here's what I have so far.
The little blue line is where a spring will go.
That's my design. I'm currently in the process of cutting it from 1/4 inch 6160 aluminum I had lying around. For the cassette I'm using 3/4 inch square aluminum tubing. 1/16th wall. I wanted 1/2 by 1, but I think i'll be able to make it work. The shaft notch piece is going to be 1/2 inch thick, because of the size of the cassette. The piece you pull will be 1/4 but will be centered on the pin using a spacer of pvc. Going good so far.
The stock I think is going to be maple, or oak. Probably do a pine one to work the bugs out.
I'm going for a 70cm trigger to band distance. I'm thinking of doing a very open track, or no track at all. Supported only at the muzzle and trigger. It's for short, low viz shots.
Probably go with one 9/16 or 5/8 band. I can always add another if I think I need it, but after talking with foxfish, I dont think I will.
The little blue line is where a spring will go.
That's my design. I'm currently in the process of cutting it from 1/4 inch 6160 aluminum I had lying around. For the cassette I'm using 3/4 inch square aluminum tubing. 1/16th wall. I wanted 1/2 by 1, but I think i'll be able to make it work. The shaft notch piece is going to be 1/2 inch thick, because of the size of the cassette. The piece you pull will be 1/4 but will be centered on the pin using a spacer of pvc. Going good so far.
The stock I think is going to be maple, or oak. Probably do a pine one to work the bugs out.
I'm going for a 70cm trigger to band distance. I'm thinking of doing a very open track, or no track at all. Supported only at the muzzle and trigger. It's for short, low viz shots.
Probably go with one 9/16 or 5/8 band. I can always add another if I think I need it, but after talking with foxfish, I dont think I will.