-
Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:
- Join over 44,280+ fellow diving enthusiasts from around the world on this forum
- Participate in and browse from over 516,210+ posts.
- Communicate privately with other divers from around the world.
- Post your own photos or view from 7,441+ user submitted images.
- All this and much more...
You can gain access to all this absolutely free when you register for an account, so sign up today!
how to make a monofin.
- Thread starterKRISTIAN
- Start date
Thread Status: Hello
, There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.
It can take a long time to get an up-to-date response or contact with relevant users.
It's a lot of work
I've made 2 and it is a lot harder than it may 1st appear. Mine were both based on the Sebak approach and used modifed OMER footpockets. Working with carbon and epoxy resins is not for the faint hearted and at the end of the day cost me not much less than what you can buy off the shelf.
Key challenges are:
- layering the glass effectively (by hand)
- getting the layering quantities right for the performance you desire
- consolidating the resin by hand so that it gives as close as possible a finish to vacuum bagging
- fixing the footpockets effectively once complete.
I've seen some plain monofins made out of a sheet of plastic that work ok, but having made my own, bought a SEBAK and now a WaterWay mono, I'll be sticking to the Waterway from this point forward.....awesome and well priced.... and after all if it's good enough for Carlos and a bunch of other legends it will sure do me.
I've made 2 and it is a lot harder than it may 1st appear. Mine were both based on the Sebak approach and used modifed OMER footpockets. Working with carbon and epoxy resins is not for the faint hearted and at the end of the day cost me not much less than what you can buy off the shelf.
Key challenges are:- layering the glass effectively (by hand)
- getting the layering quantities right for the performance you desire
- consolidating the resin by hand so that it gives as close as possible a finish to vacuum bagging
- fixing the footpockets effectively once complete.
I've seen some plain monofins made out of a sheet of plastic that work ok, but having made my own, bought a SEBAK and now a WaterWay mono, I'll be sticking to the Waterway from this point forward.....awesome and well priced.... and after all if it's good enough for Carlos and a bunch of other legends it will sure do me.