Pressure gauge and filling adapter for Cyrano

[Jason W.]

So after some fruitless searches I seek help. Where do I find a pressure gauge for my Cyrano? And while I am at it how about an adapter that would allow me to add air from a compressor. I am new to the dark side and am fumbling a little, any help at all is greatly appreciated.

 

[tromic]

[ame=http://www.youtube.com/watch?v=BCbj4XC5-Uc]YouTube - Speargun compressor[/ame]

 

[Jason W.]

YouTube - Speargun compressor

Thanks tromic,
Is that a refrigerator compressor, nice and quiet. I was planning on using a compressor designed to run pneumatic tools. What do you use for threaded fittings? Are they a standard size? Does no one make these fittings and adapters?

 

[tromic]

Thanks tromic,
Is that a refrigerator compressor, nice and quiet. I was planning on using a compressor designed to run pneumatic tools. What do you use for threaded fittings? Are they a standard size? Does no one make these fittings and adapters?

For the Cyrano gauge thread is M14/1 mm.

 

[foxfish]

Jason, I think it is a very good idea to use a pressure gauge, Omer used to sell one will a multi adaptor but, you should be able to buy a pressure gauge & the right thread connection from a local source like a hardware store.
Personally I dont have a problem using the hand pump!

 

[Don Paul]

Technosport, Inc. Spearfishing Gear.

Mark @ Technosport.

Cheers, Don

 

[Jason W.]

Thanks guys! Have a safe New Years!