So after some fruitless searches I seek help. Where do I find a pressure gauge for my Cyrano? And while I am at it how about an adapter that would allow me to add air from a compressor. I am new to the dark side and am fumbling a little, any help at all is greatly appreciated.
-
Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:
- Join over 47,943+ fellow diving enthusiasts from around the world on this forum
- Participate in and browse from over 531,990+ posts.
- Communicate privately with other divers from around the world.
- Post your own photos or view from 7,455+ user submitted images.
- All this and much more...
You can gain access to all this absolutely free when you register for an account, so sign up today!
Pressure gauge and filling adapter for Cyrano
- Thread starter Jason W.
- Start date
Thread Status: Hello
, There was no answer in this thread for more than 90 days.
It can take a long time to get an up-to-date response or contact with relevant users.
It can take a long time to get an up-to-date response or contact with relevant users.
Thanks tromic,
Is that a refrigerator compressor, nice and quiet. I was planning on using a compressor designed to run pneumatic tools. What do you use for threaded fittings? Are they a standard size? Does no one make these fittings and adapters?
Jason, I think it is a very good idea to use a pressure gauge, Omer used to sell one will a multi adaptor but, you should be able to buy a pressure gauge & the right thread connection from a local source like a hardware store.
Personally I dont have a problem using the hand pump!
Personally I dont have a problem using the hand pump!
