Question

I recieved all the gear I ordered today and I have 2 questions.
First does anyone know how to take the blades out of a pair of
cressi sub rondine gara's.I took the scews out but the fin only moves a small amount about 1\8 of an inch. Second I have a Bandito pather speargun that came with a 6mm point . I tried to put the point on the shaft but it will not fit . I bought a spair shaft
and it wil not fit that one either. I tried the tip off my pole spear
and it will not fit either shafts but the tip that came with the gun will fit pole spear.

I figured everything out . The fins weren't stuck , you have to pull the end of the footpocket ribs out to release the blades. there are little rubber post that fits in a second notch on the fins.Theyare not like the sporasubs that have only one notch.On the speargun shafts I had to use a die and rethread them,if you look at a male 6mm thread it starts out a little smaller at the tip.
These shafts had no taper at all and I went thru a whole box of adapters at the local dive shop with no luck.7mm was to big and the 6mms would only go on about three threads.The cressi fins are Compione del Mondo.The blades are about 28 inches long without the foot pockets.

Hey CDavis are there any good spots to freedive in Sarasota without a boat?