Welcome to the DeeperBlue.com Forums, the largest online community dedicated to Freediving, Scuba Diving and Spearfishing. To gain full access to the DeeperBlue.com Forums you must register for a free account. As a registered member you will be able to:
- Join over 47,943+ fellow diving enthusiasts from around the world on this forum
- Participate in and browse from over 531,990+ posts.
- Communicate privately with other divers from around the world.
- Post your own photos or view from 7,455+ user submitted images.
- All this and much more...
You can gain access to all this absolutely free when you register for an account, so sign up today!

spear shaft

Thread starter cesare
Start date Nov 17, 2006

Thread Status: Hello , There was no answer in this thread for more than 90 days.
It can take a long time to get an up-to-date response or contact with relevant users.

cesare

New Member

Nov 17, 2006

Nov 17, 2006

greetings

I reckon 17-4 ph stainless steel is the best material for spear shafts. I have access only to 304 stainless steel in my town. Is it a good material for making a spear shaft.

The spearshaft will be 72" long and 3/8" wide.

Thanks, best regards

Show hidden low quality content

You must log in or register to reply here.

Facebook X Bluesky LinkedIn Reddit Pinterest WhatsApp Email Link

Top Bottom

Back

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…